E-Tech ET8 Manual de instalación descargar pdf (Pagina 14)

PROGRAMMING

E-TECH ET8 (V4) CONTROL PANEL – INSTALLER MANUAL

USER CODES

User codes are the 3 to 6 digit codes used to operate the panel by keypad.

User Codes 1–15: Used to arm/disarm the panel. These codes can also be

programmed as Arm Only codes. User Code 1 is also the Master Code

which is used to access Client Program mode.

PROGRAMMING SEQUENCE:

P[11–25]E the existing code is displayed

[ENTER NEW CODE] E [ENTER NEW CODE AGAIN] E

the new code is displayed

EXAMPLE: To program the Master Code

Enter new code Enter new code again

TO DELETE A CODE:

To delete a User Code, enter the MEMORY key in place of the code.

EXAMPLE: To delete User Code 2:

P12E MEMORY E

ARM ONLY CODES

User Codes 2–15 can be set as Arm Only Codes. These codes can Arm but

cannot Disarm the panel.

When programming a code, enter ARM E in front of the code to enable the Arm

Only option.

EXAMPLE: To program User Code 2 to be 1234 and an Arm Only code:

P12E ARM E 1234E 1234E

When the code is viewed, the ARMED icon is displayed before the digits of the

code.

P11E – P25E

PROGRAM MODE LEVEL:

User, Installer, Remote by PC

FACTORY DEFAULT:

User Code 1: 123

Installer Code: 000000

All other codes: [blank]

NOTES:

• User Codes can be 3 to 6 digits in length.

• User codes cannot start with ‘0’.

• All codes must be unique to each other.

• User Codes 2–15 can be programmed to

be ARM ONLY codes.

• When programming a code you must

enter it twice for verification.

• To clear an existing code, re-program that

code with any number (not an existing

code) beginning with 0.

• To clear all codes (except the Installer

Code), enter P98E in Installer Program

mode. See Page 53.

• Codes are rejected if already used. Some

codes that are similar to existing codes

may also be rejected.

• Open/Close reports are identified by user

number when the control panel is base

station monitored.

INSTALLER CODE NOTES:

• All of the above notes also apply to the

Installer Code.

The function of the Installer Code is to

gain access to Installer Program Mode.

See Page 13, “How To Enter Program

Mode.”

CODE OPTION No DESCRIPTION

FACTORY

DEFAULT

User Code 1 P11E Master Code 123

(Keypad Code only)

User Code 2 P12E

User Code 3 P13E

User Code 4 P14E

User Code 5 P15E

User Code 6 P16E

User Code 7 P17E

User Code 8 P18E

User Code 9 P19E

User Code 10 P20E

User Code 11 P21E

User Code 12 P22E

User Code 13 P23E

User Code 14 P24E

User Code 15 P25E

Installer Code P99E Installer Code 000000

P09E

P10E

ENABLE AS A

RADIO CODE

CODE TABLE

Radio Key

programming,

Page 57

RADIO PROGRAMMING See pages 56,57

P01E – P10E

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 63 64

Comentarios a estos manuales

Sin comentarios

E-Tech ET8 Manual de instalación Pagina 14

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad E-Tech ET8