E-Tech ET8 Manual de instalación descargar pdf (Pagina 59)

59

E-TECH ET8 (V4) CONTROL PANEL – INSTALLER MANUAL

OPERATING THE ET8 BY TELEPHONE

The ET8 will allow a user to call in to

the panel, using a standard DTMF

telephone, and remotely Arm or

Disarm all areas and also turn on or

off Aux 1 and Aux 2.

To maintain panel security, remote

operations can only be activated

after entering a valid user code.

To operate the ET8 by telephone,

you need a DTMF capable

telephone, a valid User Code and

you must know the Telephone

number of the line to which the ET8

is connected.

NOTES

• If the ET8 does not receive

commands for periods longer than

10 seconds it will assume that the

call is finished and it will hang up.

• If an alarm occurs which requires

the ET8 to dial out while attempting

remote control, the ET8 will treat the

alarm as a priority, give a constant

tone as a warning and then hang

up.

• When all remote control

commands are finished press

to force the ET8 to hang up.

SUMMARY OF TELEPHONE COMMANDS

Prepare to receive commands

Arm Areas

Disarm Areas

Turn Aux 1 Output ON or OFF

Turn Aux 2 Output ON or OFF

Finished – hang up

AUDIBLE FEEDBACK

3 BEEPS:

• The User Code is valid

• Successful Arming or Disarming

• An Auxiliary output has been turned ON.

1 LONG BEEP:

• ET8 is already Armed

• Invalid code. Try again.

1 SHORT BEEP:

• An Auxiliary output has been turned OFF.

SEQUENCE OF OPERATION.

1. Phone the ET8 telephone number

and listen for the required

number of rings (ring ring...ring

ring) and then hang up.

2. Wait 10 seconds and then call the

number again within 50 seconds.

3. The ET8 will answer the second

call immediately, sound a beep

for 2 seconds then, after a pause,

it will sound a lower frequency

tone. The ET8 is now ready to

receive telephone commands.

4. Press the

button on the

telephone. This tells the ET8 that

telephone commands will follow.

The ET8 will respond with either 3

beeps if all OK (One long beep

means try again).

5. Now enter a valid User Code (that

is normally used for Arming or

Disarming the ET8) followed by

the

button.

The ET8 will respond with 3 beeps if

it recognises the code or 1 long

beep to signal the code was

invalid and to try again.

6. Enter the required command.

See: Summary Of Telephone

Commands.

7. Press

to finish. This tells

the ET8 to hang up. Also hang up

your telephone.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64

Comentarios a estos manuales

Sin comentarios