E-Tech ET8 Manual de instalación descargar pdf (Pagina 31)

PROGRAMMING

E-TECH ET8 (V4) CONTROL PANEL – INSTALLER MANUAL

SUPERVISED RADIO ZONES

This option assigns zones that will operate as Radio Supervised types.

Supervised signals failure is reported (as per the P66E output options) when no

signal is received from a Radio Supervision Zone for the Supervision Time

P67E.

Radio Supervision for any zone is not enabled unless a Radio PIR is assigned

to the zone, (P01E–P08E).

PROGRAMMING SEQUENCE:

P65E [Zone No]E toggles the options ON and OFF

P65E [Zone No]E OFF: The zone is not a Supervised Radio zone

P65E [Zone No]E ON: The zone is a Supervised Radio zone

P65E

PROGRAM MODE LEVEL:

Installer, Remote by PC

FACTORY DEFAULT:

all OFF: No Radio Supervision zones

NOTES:

• 0E will turn all selections OFF

MEMORY E will turn all selections ON

• RELATED OPTIONS:

P66E 1E–6E Radio Supervision Alerts

P67E Radio Supervision Time

P01E–P08E Programming Radio Devices

OPTION No DESCRIPTION 1 2 3 4 5 6 7 8

Zones

ON = Factory default setting

P65E Supervised zonesRadio

SUPERVISION TIME

The SUPERVISION TIME is the time allowed between radio transmissions

received by the ET8 from any Supervised E-Tech Radio PIR (100–663).

The SUPERVISION TIME setting is from 01 to 24 hours.

PROGRAMMING SEQUENCE:

P67E existing time is displayed [ENTER NEW TIME] E new time is displayed

EXAMPLE: To program SUPERVISION TIME to be 4 hours:

P67E 04E

P67E

PROGRAM MODE LEVEL:

Installer, Remote by PC

FACTORY DEFAULT:

24hrs

NOTES:

• A setting of less than 3 hours is not

recommended.

• The Supervision timer is reset on exit

from Installer Program Mode, on Arm or

Disarm and on reception of the

Supervision signal from the particular

Radio PIR.

• The Supervision signal from each

Supervised Radio PIR is individually

timed.

• RELATED OPTIONS:

P65E Radio Supervision Zones

P66E 1E–6E Radio Supervision Alerts

P66E 7E–8E Supervision Time Speed-up

RADIO SUPERVISION

The purpose of Radio Supervision is to verify the correct operation of

E-Tech Radio PIRs. The Supervision signal from the Radio PIR tells the

panel that the device has not been removed from radio range and is

in working order.

Non-SUPERVISION Radio PIRs can also be programmed and used

with the ET8 SUPERVISION TIMERS.

A non-SUPERVISION enabled Radio PIR will transmit signals to the

ET8 only when it has detected an event. Obviously, there is no

guaranteed signal period.

In either case, when the allowed time limit is exceeded then a

WARNING is first given (if programmed by P66E 3E), and then after 1

minute, the programmed RADIO SUPERVISION ALERTS are

generated by the ET8.

NOTE: Manually Excluding a Supervised Zone will also disable Radio

Supervision for that zone.

RADIO SUPERVISION ALERTS, SUPERVISION TIME SPEEDUP

See pages 32–33

P66E 1E–6E

See Page 56 for

Radio Device programming

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 63 64

Comentarios a estos manuales

Sin comentarios

E-Tech ET8 Manual de instalación Pagina 31

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad E-Tech ET8